Language
+86 0760 22818339 Daling industrial area, Jiangling westroad, High-techzone, Zhongshan, Guangdong, China
SCT19010075
#1 in China
Suplier in region
Get A Quote

Five points to note about maintaining glass pivot shower door


   In order to prevent the glass pivot shower door from exploding, we should maintain the glass pivot shower door from time to time. The following briefly describes how to properly maintain the glass pivot shower door.
 
   1. Avoid being hit and scratched by sharp objects
       Although toughened glass has strong load-bearing capacity, it also has a fatal flaw, that is, it is afraid of being hit and scratched by sharp objects. Because the contact area of ​​sharp objects is relatively small and the pressure on the glass is strong, the glass is more likely to crack. A little cracking has shown that the whole piece of glass has been greatly damaged and has a great impact on the shower room.
  pivot glass shower door
   2. Key protection glass corners
      The middle part of tempered glass is the strongest, while the corners and edges are relatively fragile. Once cracks appear, it means that the whole piece of glass is easily broken. For example: Just like when we usually take a bus, there is a safety hammer on the window glass, so the principle is the same. Therefore, we should always pay attention to check whether there are cracks at the corners and edges of the glass pivot shower door.

   Three, stick on explosion-proof film to reduce the hazard of self-explosion
       The explosion-proof film can increase the strength of the tempered glass. Even if the tempered glass bursts, the self-explosive glass fragments can be glued together by the adhesive force of the explosion-proof film. This can effectively prevent the glass fragments from splashing and hurting people after the tempered glass explodes.

  Four. Do not switch too much force
       Although the strength of the tempered glass in the shower room is relatively high, and its performance in all aspects is relatively strong, it should not be treated roughly, such as using very strong force to switch.
  
   5. Avoid high temperature pressure on glass
      The interior of the shower room is a relatively sealed space. Because the accumulation of high temperature and high pressure is easier to cause pressure on the glass, it is recommended not to adjust the water temperature to a high temperature all at once, but gradually increase the water temperature.

Get In Tohch